Essae DS-215N No Sensing Error
NO SENSING
No Sensing Error indicates that the indicator cannot detect a valid load cell signal.
Possible Causes
1.) Load cell disconnected.
2.) Open circuit in cable.
3.) Damaged load cell.
4.) Connector failure.
5.) Indicator fault.
Troubleshooting Procedure
1.) Switch OFF the indicator.
2.) Inspect all load cell connections.
3.) Verify cable continuity.
4.) Check load cell resistance.
5.) Restart the system.
6.) Perform calibration verification.
7.) Contact authorized service if required.
Prevention
1.) Inspect wiring regularly.
2.) Avoid cable strain.
3.) Protect connectors from moisture.
Possible Causes
1.) Load cell disconnected.
2.) Open circuit in cable.
3.) Damaged load cell.
4.) Connector failure.
5.) Indicator fault.
Troubleshooting Procedure
1.) Switch OFF the indicator.
2.) Inspect all load cell connections.
3.) Verify cable continuity.
4.) Check load cell resistance.
5.) Restart the system.
6.) Perform calibration verification.
7.) Contact authorized service if required.
Prevention
1.) Inspect wiring regularly.
2.) Avoid cable strain.
3.) Protect connectors from moisture.
Is your scale beyond repair?
Sometimes replacing an aging machine is more cost-effective than fixing it. Explore our wide range of new, high-precision weighing scales.
Related Error Codes
Related Calibration Guides
